20fe38e75a
Move SYSCFG clock setup into configure_clocks() instead of calling clock_setup() from board file. As this clock is only needed in case of ethernet enabled and as both stm32f4 and stm32f7 are using the Designware ethernet IP, we use CONFIG_ETH_DESIGNWARE to only enable this clock if needed. Move the RMII setup from board_early_init_f() to board_init() to insure that RMII bit is set only when clock driver is initialized. Signed-off-by: Patrice Chotard <patrice.chotard@st.com> |
||
|---|---|---|
| .. | ||
| gpio.h | ||
| gpt.h | ||
| stm32.h | ||
| stm32_defs.h | ||
| stm32_periph.h | ||
| stm32_pwr.h | ||
| syscfg.h | ||