54 lines
1.6 KiB
Plaintext
54 lines
1.6 KiB
Plaintext
Marvell U-Boot Build Instructions
|
|
=================================
|
|
|
|
This document describes how to compile the U-Boot and how to change U-Boot configuration
|
|
|
|
Build Procedure
|
|
----------------
|
|
1. Install required packages:
|
|
|
|
# sudo apt-get install libssl-dev
|
|
# sudo apt-get install device-tree-compiler
|
|
# sudo apt-get install swig libpython-dev
|
|
|
|
2. Set the cross compiler:
|
|
|
|
# export CROSS_COMPILE=/path/to/toolchain/aarch64-marvell-linux-gnu-
|
|
|
|
3. Clean-up old residuals:
|
|
|
|
# make mrproper
|
|
|
|
4. Configure the U-Boot:
|
|
|
|
# make <defconfig_file>
|
|
|
|
- For the Armada-70x0/80x0 DB board use "mvebu_db_armada8k_defconfig"
|
|
- For the Armada-80x0 MacchiatoBin use "make mvebu_mcbin-88f8040_defconfig"
|
|
- For the Armada-3700 DB board use "make mvebu_db-88f3720_defconfig"
|
|
- For the Armada-3700 EsspressoBin use "make mvebu_espressobin-88f3720_defconfig"
|
|
|
|
5. Configure the device-tree and build the U-Boot image:
|
|
|
|
Compile u-boot and set the required device-tree using:
|
|
|
|
# make DEVICE_TREE=<name>
|
|
|
|
NOTE:
|
|
Compilation with "mvebu_db_armada8k_defconfig" requires explicitly exporting DEVICE_TREE
|
|
for the requested board.
|
|
By default, u-boot is compiled with armada-8040-db device-tree.
|
|
Using A80x0 device-tree on A70x0 might break the device.
|
|
In order to prevent this, the required device-tree MUST be set during compilation.
|
|
All device-tree files are located in ./arch/arm/dts/ folder.
|
|
|
|
NOTE:
|
|
The u-boot.bin should not be used as a stand-alone image.
|
|
The ARM Trusted Firmware (ATF) build process uses this image to generate the
|
|
flash image.
|
|
|
|
Configuration update
|
|
---------------------
|
|
To update the U-Boot configuration, please refer to doc/README.kconfig
|
|
|