diff --git a/README.md b/README.md index 9ca95da..2426845 100644 --- a/README.md +++ b/README.md @@ -11,14 +11,11 @@ git submodule init git submodule update ``` -### Copy PFE firmware -Please make sure that you copy the PFE firmware with the right version meta-netmodule-bsp/recipes-kernel/pfe/pfe_ to meta-netmodule-bsp/recipes-kernel/pfe/pfe/. You need to copy the class and util firmware files. This is necessary because the firmware is currently only available under NDA. - ## Selecting hardware target The hardware target can be selected by sourcing the machine_select script: ``` source machine_select -9 # Selecting ProCV2.2 +9 # Selecting VCU3 ``` ## Building an image @@ -54,79 +51,3 @@ It can be build with the following commands: source env.image-ostree bitbake netmodule-linux-image-dev ``` - -## Usage - -### 1000BaseT1 - -The PFE driver comes up automatically. However, it does by default rely on autoneg. This doesn't seem to work with the Göpel Media Converter EasyCON. Therefore, a reset is required. Currently pfe0 shares the reset signal with eth0. That's why the following works: -``` -brginup.sh enable-pfe -ifconfig eth0 down -ifconfig eth0 up -``` -Now the 1000BaseT1 PHY works in default mode. - -### Modem -The modem is disabled by default. However, it is possible to enable it with the following command: -``` -bringup.sh enable-modem -``` - -To use adb you have to do the following: -``` -echo 0x2c7c >> ~/.android/adb_usb.ini -adb shell -``` - -### Wifi -Enable the Wifi module (make sure you enable the modem first): -``` -bringup.sh enable-wifi -``` - -### ADCs -Read out the SPI ADCs: -``` -bringup.sh read-adc -``` - -### IMU -To enable the IMU you can call enable-imu.sh: -``` -bringup.sh enable-imu.sh -``` - -To communicate with the imu you can use test-imu.sh: -``` -# Read/Write -bringup.sh read-write-imu /dev/spidev1.0 1 2020 -# Read -bringup.sh read-write-imu /dev/spidev1.0 1 -``` - -### Secure Element -To enable the secure elelment call enable-secure-element: -``` -bringup.sh enable-secure-element -``` -There is no helper for the secure element available yet. You can use spidev_test to communicate with it: -``` -spidev_test --help -``` - -### V2X -Enable the V2X and load a firmware (make sure you enable the modem first): -``` -bringup.sh enable-v2x -``` - -### GPIOS -Set gpio: -``` -bringup.sh set-gpio -``` -Get gpio: -``` -bringup.sh get-gpio -```